Gearbox check

• Set up on 4” block as photo

• Put into 3^rd gear to check dog penetration it should be flush with penetrated gear (1^st)

• Remove Neutral Holder Ball and spring (from the underside of the engine)

• Tap Out gearbox shafts evenly to remove as a single unit

• Check dogs for rounded corners and bits missing of face

• Clean and inspect Selector drum
• Clean and inspect fork shaft  Roll on machine table to check for bend any more than 1 thou is to much

• Check selector forks for wear, photos show different stage of wear

• Output shaft on roller bearing???
• Check all bearings in cases for cracks flat spots rough to turn replace as required